VisionPRO TM 8000 Touchscreen Programmable Thermostat
OPERATION
Thermostat Keys
SYSTEM
SELECTS EM.
_::T/H EAT/OFF/COOL_
7 /
LI_I
nu' "3 Zo
DOWN ARROW
LOWERS TEMPERATURE
_ SETTING
'_ UP ARROW
RAISES
TEMPERATURE
_ SETTING
Set ToED2_
Following
Schedule
SCHEDJ/CLOCK /&ORE
ENTER_ SETS THE Isc!HOWS ADDITIONAL
SCHEDULING TIME ACCESSORY AND
MODE FORWARD MAINTENANCE
OR BACK OPTIONS
HOLD
SETS A PERMANENT EEN
HOLD AND ACTIVITIES LOCKS OUT THE
VACATION HOLD SCREEN TO ALLOW
FOR CLEANING
M22444
Thermostat Display
TUE
SHOWS CURRENT DAY
OF THE WEEK -
FAN
SHOWS FAN
SETTING 1
SYSTEM =
SHOWS
CURRENT
SYSTEM
POSITION
INSIDE TEMPERATURE
SHOWS THE CURRENT INSIDE
TEMPERATURE
-- SET TO
/ TEMPERATURE
SHOWSTHE
CURRENTSET
TEMPERATURE
L_JJ'n_'_!ZCICl-Iso,Tor_cDc.-0
IU _J /
T,ME2 LFOLLOW,HG
D,SPLA CURRENTSOHEDOLE
TIME OF DAY, HOLD SHOWS THE
TIME REMAINING OR THERMOSTAT IS
NUMBER OF VACATION FOLLOWING THE
DAYS REMAINING PROGRAMMED
SCHEDULE
Systemand Fan Settings
System
The System key selections vary based on your heating and/or
cooling system type.
Heat -- Thermostat controls the heating system.
Off- Both heating and cooling systems are off.
Cool -- Thermostat controls the cooling system.
Auto -- Thermostat automatically changes between heating
and cooling operation, depending on indoor temperature.
Em. Heat -- Emergency heat cycles to maintain temperature.
Compressor is locked out (used only for 2H/1C or 3H/2C heat
pump systems) and auxiliary heat turns on as second stage if
needed.
Fan
The Fan key selections vary based on the heating and/or
cooling system type.
On -- Fan runs continuously. Use this setting for improved air
circulation or for more efficient central air cleaning.
Auto -- fan follows the fan program schedule.
Circ -- fan runs randomly approximately 35% of the time.
Use this setting for improved air circulation or for more
efficient central air cleaning when you do not want the fan
running continuously.
UserSetup
Follow these steps to enter the User Setup:
1. Press and release the System key.
M22426A
21 68-0280
To Next Page
Loading...
