VisionPRO TM 8000 Touchscreen Programmable Thermostat
4-5/8
(117)
ttoneyweil
I_-----"""- 2-3/4 (70)-_--_-I
M4465 FRONT VIEW
_'_ 1-118 --'_'1
(29)
SIDE VIEW
V
4-5/8
(117)
3-I/4
(83)
B:g C:_
¢ }
2-3/4 (70)
FRONT VIEW (COVER OFF)
Fig. 4. C7189U Remote Indoor Sensor dimensions in in. (mm).
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow the
instructions can damage the product or cause a hazard-
ous condition.
2. Check the ratings given in the instructions to make sure
the product is suitable for your application.
3. Installer must be a trained, experienced service
technician.
4. After completing installation, use these instructions to
check out the product operation.
Selecting Location
Install the thermostat about 5 ft. (1.5m) above the floor in an
area with good air circulation at average temperature. See
Fig. 5.
M19925
Fig. 5. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
-- Drafts or dead spots behind doors and in corners.
-- Hot or cold air from ducts.
-- Radiant heat from sun or appliances.
-- Concealed pipes and chimneys.
-- Unheated (uncooled) areas such as an outside wall behind
the thermostat.
Installing Wallplate
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before wiring.
The thermostat can be mounted horizontally on the wall or on
a 4 in. x 2 in. (101.6 mmx 50.8 mm) wiring box.
1,
2.
3.
Position and level the wallplate (for appearance only).
Use a pencil to mark the mounting holes.
Remove the wallplate from the wall and, if drywall, drill
two 3/16-in. holes in the wall, as marked. For firmer
material such as plaster, drill two 7/32-in. holes. Gently
tap anchors (provided) into the drilled holes until flush
with the wall.
68-0280 4
To Next Page
Loading...
