VisionPRO TM 8000 Touchscreen Programmable Thermostat
Replace Batteries
1. When the LO Battery indicator is flashing, replace the
batteries promptly with three fresh AAA alkaline
batteries
4,
Align the screw blocks with the pins on the back of the
thermostat.
_a-_ C C
SCREW
BLOCK
PINS ON
BACK OF
THERMOSTAT
M19963
2. Remove thermostat from the wallplate by pulling
straight out.
M22430
3. Remove the old batteries and insert three fresh AAA
alkaline batteries, as marked on the thermostat.
M22213
5. Push the thermostat straight onto the wallplate until it
snaps into place.
Battery Tips
1. Replace the batteries as soon as LO Batt flashes in the
display. The LO Battery indicator flashes in the display
one month before the batteries run down completely.
2. Always use fresh AAA alkaline batteries. Non-alkaline
batteries do not last as long and can leak, causing
thermostat damage.
3. Although the thermostat has a Low Battery indicator,
replace the batteries once a year to prevent the thermo-
stat and heating/cooling system from shutting down due
to lack of battery power.
ScreenLocks
0
(3) M22212
TUE
_lnside _
ClZl
_l
--M I--|
--r-I P_
oc
Following
Schedule
M19965
68-0280 28
To Next Page
Loading...
