Honeywell VisionPRO 8000 - Page 30

VisionPRO TM 8000 Touchscreen Programmable Thermostat
The remaining run time days can be viewed by pressing the
More key; the remaining days can be edited using the More
key or from the Installer Setup. To view or reset the reminder
before it expires, follow these steps using the More key:
1. Press the More key until the filter reminder appears on
the screen. This is the number of fan run-time days
remaining on the filter reminder.
FILTER
_--II--I
Zll_l DAYS
M22449
Press the Edit key.
Use the Up and Down keys to change the number of
run-time days.
FILTER
"-II--I
_Bl_J DAYS
M22450
4. Press the Done key to go back to the viewing screen.
5,
6,
FILTER
I-II-I
M22449
Press the Reset key to activate the new number of days
selected in the previous screen.
FILTER
-IN
_ DAYS
M22451
Press the Done key to return to the Home screen.
68-0280 30