Honeywell VisionPRO 8000 - Page 36

VISIONPRO
®
8000 WITH WI-FI
®
33-00096—01 36
1402 Indoor
Temperature
Offset
-3° F to 3° F (in 1° F increments)
0° F Both 0° F - No difference in displayed temperature
and the actual room temperature.
The thermostat displays up to 3°F (1.5°C) lower
or higher than the actual measured
temperature.
1402 Indoor Humidity
Offset
-12% to 12% (in 1% increments)
0% Both 0% - No difference in displayed humidity and
the actual room humidity.
The thermostat displays up to 12% lower or
higher than the actual measured humidity.
1404 Alert Light
Indicator
On
Off
On Both The thermostat has a built in light indicator.
When an alert is active, the light will be on
continuous if the thermostat is powered with 24
VAC (C wire) or it will flash if the thermostat is
powered with batteries only. The light also turns
on when the system setting is set to Em Heat.
Select On to use the light indicator or select Off
to turn off the light.
1500 Dealer Name
[Dealer Name]
None Both Dealer information is displayed to the user when
an alert is active and the user can access this
information by selecting "Dealer Information" in
the Menu.
1500 Dealer Phone
[Dealer Phone]
None Both
1501 Dealer Email
Address
[Dealer Email Address]
None Both
1501 Dealer Website
[Dealer Website]
None Both
1502 Dealer Message
[Dealer Message]
None Both
Table 2. Installer Setup (ISU) Table. (Continued)
ISU
Number
Installer Setup
Name Settings Default
Residential,
Commercial
or Both Notes