EasyManua.ls Logo

Honeywell VisionPRO 8000 - Page 47

Honeywell VisionPRO 8000
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VISIONPRO
®
8000 WITH WI-FI
®
47 33-00096—01
Fig. 65.
Touch the or buttons to set the temperature or the Hold
Until time. The temperature is maintained until the time you set.
Temperature returns to an energy-saving level after the timer
expires, or the “Occupied” period ends.
NOTE: This feature is available only when programmed
by the installer.
Adjusting Humidification Settings
1. Touch MENU and select Humidification.
Fig. 66.
Fig. 67.
2. Select Auto.
Fig. 68.
3. Touch or to select humidity level.
4. Touch Done to save your settings. Touch Cancel to
ignore changes.
5. If frost or condensation appears on the windows, press
MENU, scroll down and select Window Protection.
Fig. 69.
6. Window Protection is set on a scale from 1–10. A setting
of 1 represents poorly insulated windows and a setting of
10 represents well insulated windows. A lower number
automatically reduces the humidity to help prevent frost
or condensation on your windows. Use a higher number
if indoor air seems too dry. To prevent frost/condensation
on your windows during cold outdoor temperatures,
poorly insulated windows require a lower Window Pro-
tection setting, which will limit how much your humidifier
can run.
7. After you set the Window Protection setting, check for
frost/condensation on your windows in the morning. If
frost/condensation is present, adjust the Window Protec-
tion setting to the next lowest number and check for frost/
condensation on your windows the next morning. Con-
tinue to adjust the Window Protection setting to a lower
number until frost/condensation is no longer present.
NOTE: Window Protection is available only if connected
to an outdoor wired sensor or to the Internet.
NOTE: The thermostat controls humidification and dehu-
midification as needed to maintain the desired
humidity level. Depending on how your thermo-
stat was installed, the thermostat may maintain a
15% separation between humidification and dehu-
midification settings.
Adjusting Dehumidification Settings:
Residential Use
This feature can control a dehumidifier or use your air
conditioner to reduce humidity.
M34127
Press HERE to
Start Occupancy
MCR34100
MCR34128
Humidification
Window Protection
MCR34129
Humidification
Off Auto

Table of Contents

Other manuals for Honeywell VisionPRO 8000

Related product manuals