Honeywell VOYAGER 1250G User Manual

3 - 19
SEQBLKsequence editor start command
62 code identifier for Code 39
0012 A - Code 39 sample length (11) plus CR suffix (1) = 12
41 start character match for Code 39, 41h = “A”
FF termination string for first code
6A code identifier for Code 128
0013 B - Code 128 sample length (12) plus CR suffix (1) = 13
42 start character match for Code 128, 42h = “B”
FF termination string for second code
69 code identifier for Code 93
0012 C - Code 93 sample length (11) plus CR suffix (1) = 12
43 start character match for Code 93, 43h = “C”
FF termination string for third code
Output Sequence Editor
Sequence Timeout
You may wish to set the maximum time between bar code scans in an out-
put sequence. If that maximum time is not met, the output sequence oper-
ation is terminated. Set the length (in milliseconds) for a timeout by
scanning the bar code below, then setting the timeout (from 1-65535 milli-
seconds) by scanning digits from the Programming Chart, then scanning
Save.
Default = 5000 msec.
Default Sequence
Enter Sequence
Sequence Timeout

Honeywell VOYAGER 1250G Specifications

General

Sensor type	Laser
Scanner type	1D
Tilt angle range	-30 - 30 °
Decoding standards	1D, GS1
Pitch reading angle	-60 - 60 °
Light levels (direct sunlight)	0 - 75000 lx
Standard interfaces	USB, RS-232
Input voltage	5 V
Power consumption	140 mA
Shockproof	Yes
Dimensions (WxDxH)	168 x 60 x 74 mm
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Weight	133 g