EasyManua.ls Logo

Honeywell Voyager 1470g - Scanner-Bioptic ACK;NAK Mode; Scanner-Bioptic ACK;NAK Timeout

Honeywell Voyager 1470g
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36 Voyager XP User Guide
Scanner-Bioptic ACK/NAK Mode
Bioptic ACK/Nak On must be scanned so the scanner will wait for an ACK or NAK
from a bioptic scanner after each packet is sent. The Scanner-Bioptic ACK/NAK
Timeout (below) controls how long the scanner will wait for a response. Default =
Bioptic ACK/NAK Off.
Scanner-Bioptic ACK/NAK Timeout
This allows you to set the length (in milliseconds) for a timeout for a bioptic
scanner’s ACK/NAK response. Scan the barcode below, then set the timeout (from
1-30,000 milliseconds) by scanning digits from the Programming Chart, then
scanning Save. Default = 5100.
* Bioptic ACK/NAK Off
Bioptic ACK/NAK On
ACK/NAK Timeout

Table of Contents

Related product manuals