EasyManuals Logo

Honeywell Voyager 1470g User Manual

Honeywell Voyager 1470g
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
60 Voyager XP User Guide
To put the scanner in multiple scanner mode, scan the barcode below. Once you
scan this barcode, the scanner is unlinked from the base or Access Point and must
either be placed into the base, or you must scan the Access Point linking barcode in
order to relink.
Scanner Name
You may assign a name to each scanner you are using for identification purposes.
For example, you may want to have a unique identifier for a scanner that is receiv-
ing imaging commands sent from the base or Access Point.
The default name is in the format “ScannerName_Model_SN_XXXXXXXXXX” If you
have more than one scanner linked to a base, and they all have the same name, the
first scanner linked to the base receives commands. When renaming a series of
scanners with identical names, unlink all except one of the scanners from the base.
Perform the rename operation using either the barcodes on page 61, or by sending
the serial command :ScannerName:BT_NAMNewName. where ScannerName is the
current name of the scanner, and NewName is the new name for the scanner. If you
wish to change the names of additional scanners, link them one at a time and
repeat the :ScannerName:BT_NAMNewName. command for each scanner.
To rename scanners with sequential, numeric names, scan the barcodes below.
Scan the Reset code after each name change and wait for the scanner to relink to
the base or Access Point before scanning a barcode to rename the next scanner.
Multiple Scanner Operation
0001
0002
0003
0004
0005

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Voyager 1470g and is the answer not in the manual?

Honeywell Voyager 1470g Specifications

General IconGeneral
Operating Temperature0°C to 50°C (32°F to 122°F)
Environmental SealingIP40
Motion ToleranceUp to 70 cm/s (27.6 in/s) for 13 mil UPC at optimal focus
Storage Temperature-40°C to 60°C (-40°F to 140°F)
Weight130 g (4.6 oz)
Humidity0% to 95% relative humidity, non-condensing
Scan PatternOmnidirectional
ConnectivityUSB, RS-232, Keyboard Wedge
Decode CapabilityReads standard 1D
Drop SpecificationWithstands multiple 1.5 m (5 ft) drops to concrete
Light Levels0 to 100, 000 lux
Dimensions62 mm x 169 mm x 82 mm (2.5 in x 6.6 in x 3.2 in)
Light SourceLED

Related product manuals