EasyManua.ls Logo

Honeywell Voyager 1470g - Batch Mode Beep; Batch Mode Storage

Honeywell Voyager 1470g
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Voyager XP User Guide 55
Batch Mode Beep
When scanning in Inventory Batch Mode, the scanner beeps every time a barcode
is scanned. When Batch Mode Beep is On, you will also hear a click when each bar-
code is sent to the host. If you do not want to hear these clicks, scan Batch Mode
Beep Off. Default = Batch Mode Beep On.
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can select
whether the data is stored in Flash memory or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to
powering down. The data will still be there when the scanner powers back up. How-
ever, the scanner will power down, even with untransmitted data, if it reaches a
power down timeout or if the battery power is very low.
RAM Storage: The scanner will not power down while it contains data that has not
been transmitted to the base or Access Point, even if it reaches a power down time-
out. However, if the scanner runs out of battery power, it will power down and the
data will be lost.
Default = Flash Storage.
Batch Mode Beep Off
* Batch Mode Beep On
* Flash Storage
RAM Storage

Table of Contents

Related product manuals