Honeywell XENON 1902

v
Beeper Pitch – Error.............................................. 4-5
Beeper Duration – Good Read.............................. 4-5
LED – Good Read................................................. 4-5
Number of Beeps – Good Read............................ 4-6
Number of Beeps – Error ...................................... 4-6
Beeper Volume Max.............................................. 4-6
Good Read Delay.................................................. 4-7
User-Specified Good Read Delay ......................... 4-7
Manual Trigger Modes ................................................ 4-7
LED Illumination - Manual Trigger......................... 4-8
Serial Trigger Mode..................................................... 4-9
Read Time-Out...................................................... 4-9
Presentation Mode ...................................................... 4-9
LED Illumination - Presentation Mode................. 4-10
Presentation LED Behavior after Decode ........... 4-10
Presentation Sensitivity....................................... 4-11
Presentation Centering........................................ 4-11
In-Stand Sensor Mode .............................................. 4-14
CodeGate
®
................................................................ 4-14
Streaming Presentation™ Mode ............................... 4-15
Streaming Presentation In-Stand Programming.. 4-15
Mobile Phone Read Mode......................................... 4-16
Hands Free Time-Out ............................................... 4-16
Reread Delay ............................................................ 4-16
User-Specified Reread Delay.................................... 4-17
Illumination Lights ..................................................... 4-18
Aimer Delay............................................................... 4-18
User-Specified Aimer Delay ................................ 4-18
Scanner Time-Out..................................................... 4-19
Aimer Mode............................................................... 4-19
Centering................................................................... 4-19
Preferred Symbology ................................................ 4-21
High Priority Symbology...................................... 4-22
Low Priority Symbology....................................... 4-22
Preferred Symbology Time-out ........................... 4-22
Preferred Symbology Default .............................. 4-23
Output Sequence Overview ...................................... 4-23