Honeywell XENON 1902

vi
Require Output Sequence ...................................4-23
Output Sequence Editor ......................................4-23
To Add an Output Sequence ...............................4-24
Other Programming Selections............................4-24
Output Sequence Editor ......................................4-26
Partial Sequence .................................................4-26
Require Output Sequence ...................................4-27
Multiple Symbols........................................................4-27
No Read.....................................................................4-28
Video Reverse ...........................................................4-28
Working Orientation...................................................4-29
Chapter 5 - Data Editing
Prefix/Suffix Overview..................................................5-1
To Add a Prefix or Suffix:.......................................5-1
To Clear One or All Prefixes or Suffixes ................5-2
To Add a Carriage Return Suffix
to All Symbologies............................................5-3
Prefix Selections..........................................................5-3
Suffix Selections ..........................................................5-3
Function Code Transmit ..............................................5-4
Intercharacter, Interfunction,
and Intermessage Delays..........................................5-4
Intercharacter Delay ..............................................5-5
User Specified Intercharacter Delay ......................5-5
Interfunction Delay.................................................5-6
Intermessage Delay...............................................5-6
Chapter 6 - Data Formatting
Data Format Editor Introduction...................................6-1
Add a Data Format ......................................................6-1
Other Programming Selections..............................6-3
Terminal ID Table ........................................................6-4
Data Format Editor Commands...................................6-4
Move Commands...................................................6-9
Search Commands ..............................................6-10