Need help?Do you have a question about the Honeywell XENON 1902G-BF and is the answer not in the manual?
Provides installation and programming instructions for Xenon and Granit scanners.
Steps to take after opening the shipping carton to unpack the product.
Instructions on connecting the scanner or cordless base to a computer.
Describes how to program the system for the desired interface.
Provides instant scanner setup for commonly used interfaces via bar codes.
Instructions for programming the scanner for an IBM PC AT keyboard wedge interface.
Configures scanner and base to beep upon power up.
Enables or disables an audible click when the scanner trigger is pressed.
Settings for audible and visual feedback for good reads and errors.
Explains how to add data characters before or after scanned data.
Step-by-step guide to adding prefix or suffix characters to symbologies.
Options to delete specific or all prefixes/suffixes for a symbology.
Allows enabling or disabling all symbologies or selecting specific ones.
Explains how to set valid reading lengths for bar code symbologies.
Configuration options for the Codabar symbology.
Details mechanical, electrical, aiming, and environmental specifications.
Details mechanical, electrical, radio, and environmental specifications.
States that repairs must be performed by an authorized service center.
Provides guidance on periodic checks for dependable operation.
Instructions for cleaning the scanner housing and window.
To Next Page
General