Why does seed jump out of seed furrow in horsch SPRINTER 11 NT?
If the seed jumps out of the seed furrow with your Horsch Farm Equipment, it might be because the fan speed is too high. Try reducing the fan speed to resolve this issue.
What to do if seed remains in the seed hoses in horsch SPRINTER 11 NT Farm Equipment?
If the seed remains in the seed hoses of your Horsch Farm Equipment, the fan speed might be too low. To fix this, increase the fan speed.
Why do rollers sink into loose soil on horsch SPRINTER 11 NT?
If the rollers on your Horsch Farm Equipment sink into loose soil, the pre-load might be too high. You should reduce the pre-load; see chapter Adjusting the working depth.
Why are rear support wheels lifted on horsch SPRINTER 11 NT?
If the rear support wheels on your Horsch Farm Equipment are lifted (over approx. 20 cm), it could be that the pre-load is too high. Reduce the pre-load; see chapter Adjusting the working depth.
What to do if seed is not sufficiently covered by horsch SPRINTER 11 NT Farm Equipment?
If the seed is not sufficiently covered or pressed down by your Horsch Farm Equipment, there are a couple of potential causes: * The pre-load might be too low. Increase pre-load; see chapter Adjusting the working depth. * The serrated segment of rollers might be misaligned or loose. Readjust the serrated segment or fasten it again; see chapter Adjusting the working depth.
What to do if placement depth is too low on Horsch Farm Equipment?
If the placement depth is too low and the tines are not quiet in the soil with your Horsch Farm Equipment, consider these potential causes: * The pre-load might be too low. Increase pre-load; see chapter Adjusting the working depth. * The serrated segment of rollers might be misaligned or loose. Readjust the serrated segment or fasten again; see chapter Adjusting the working depth.
General| Brand | horsch |
|---|---|
| Model | SPRINTER 11 NT |
| Category | Farm Equipment |
| Language | English |
To Next Page