Care and maintenance
Inappropriate care and maintenance puts the
operational safety of the machine at risk. This
can lead to accidents with severe or even fatal
physical injuries.
¾ Conform with prescribed schedules for repeti-
tive tests or inspections.
¾ Service the machine according to the
maintenance plan, see chapter "Care and
maintenance".
¾ Only perform the work described in these
operating instructions.
¾ Before starting maintenance and service work
park the machine on level and rm ground and
secure it against rolling away.
¾ De-pressurise the hydraulic system and lower
or support the implement.
¾ Prior to working on the electrical system,
disconnect it from the electric current supply.
¾ When performing welding work on the ma-
chine, disconnect the cables from computers
and other electronic components. The ground
connection must be as close as possible to
the welding point.
¾ Before cleaning the machine with high pres-
sure cleaning equipment cover all openings,
which should stay clear of water, steam or
cleaning agents for reasons of safety or op-
eration. Do not aim the water jet directly on
electric or electronic parts, on bearings or the
fan.When using high pressure or steam clean-
ing equipment, you should always keep an at
least 50 cm distance from such machine parts.
¾ After cleaning, check all hydraulic lines for
leaks and loose connections.
¾ Check for chang and signs of other damage.
Remedy any faults immediately!
¾ Screw connections loosened for the purpose
of care and maintenance work must be
retighten after work is completed.
¾ All other maintenance and repair tasks,
which are not described in the operating
instructions, must only be carried out by
an authorized professional workshop or
by an operator who has been trained by
HORSCH for this purpose.
Do not clean new machines with a steam
jet of a high pressure cleaner. The paint
takes approx. 3 months to cure and
could thus be damaged if this time has
not yet expired.
13
To Next Page
Loading...
