Internal temperature is the best test of doneness
Temp Cook takes the guesswork out of cooking,
for many foods.
because the oven automatically switches to “Hold”
Use Temp Cook to cook a variety of foods to the
setting after reaching the preset food temperature
desired
ftished
food temperature. The Time Cook
and maintains that temperature until you touch the
setting is recommended for batters, doughs, frozen
CLEAWOFF
pad.
foods and foods which are
difflcdt
to cook
NOTE: Oven automatically switches to “Hold”
precisely with the probe.
when preset food temperature is reached.
The Temperature Probe
The temperature probe is a food thermometer
that gauges the
intemd temperature of your food.
(Its appearance may vary from picture shown.) The
probe must be used when using Temp Cook or Auto
Roast. To use the probe properly, follow directions in
the Automatic Roasting section.
How to Temp Cook a
RoUed
Beef Rib Roast to Medium
Step 1:
Insert temperature probe
and
attach probe
securely in oven
wrdl.
Close the door.
o
Step
2: Touch TEMP COOK pad.
TEMP
COOK
use probe
Step
3: Touch 1,6 and O for
160°F.
m
Step 4: Touch
POWR
LEVEL
pad. Touch 5 for medium power.
D
Step
5: Touch the START pad.
START
If
intemd
temperature of the roast
is less than
90°F.,
display will
show “COOL”; if temperature is
90°F.
or above, display shows
temperature counting up.
Step
6:
men
160°F.
is reached, the oven
will
sound
and
display “Hold.” The oven will then hold the
temperature.
m
Step
7: Touch the
CLEAWOFF
pad to stop the cycle.
Step 8:
Remove probe and food from the oven.
Cooking Tips
●
Use a lower power level; foods will heat more
●
Cover foods loosely for moisture
contiol
and quick,
evenly though requiring more time.
even heating.
●
Be sure frozen food has been completely defrosted
●
Insert the probe
horizontily
into the center meaty
before inserting probe. Probe may break off if used
area not touching bone or fat. Make sure the
hande
in
frozen foods.
does not touch the food or top or sides of the oven.
Questions and Answers
Q. Why did “PRObE” flash on the display after I
Q.
Can I leave my probe in the oven
ifit’s
not
touched the START pad?
inserted in food?
A.
“PRObE”
will flash if you don’t seat the cable
A. No,
if it touches the oven wall, it may damage
end of the probe securely into the receptacle in
the oven.
the oven wdl or if you touch the TEMP COOK
pad and forget to use the probe.
15
To Next Page
Loading...
