Hotpoint RVM225BL - Light Bulb Replacement

LIG~ B~B ~PLACEmm
Cooktop Light
To replace
cooktop light,
f~st discouect
power at main
fuse or circuit
breaker panel
or pti plug.
REMOVE SCREW
Remove screw on right side of light compartment
cover and lower cover until it stops.
Be sure bulbs to
be replaced are
cool before
removing. Break
the adhesive
sed by
gently unscrewing
the bulbs. Replace
\
with 40-watt
incandescent bulbs ~B02X4253) available from
your Hotpoint supplier. High intensity 40-watt bulbs
(40SllN/1), which are available in supermarkets and
hardware stores, may rdso be used for replacements.
Raise
tight compartment cover and replace screw.
Connect electrical power to microwave oven.
Oven Light
To replace your oven light, fwst
disconnect power at main fuse
or circuit breaker panel or
pu~
plug.
Remove the top @l by
taking out the 2 screws that hold
it in place.
Next, remove the single screw
located above door
nem center
of oven that secures light housing.
Replace burned-out bulb with
a 30-watt incandescent bulb
(W02X4235), available horn
your
Hotpoint supplier.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken
meti.
24