Hotpoint RVM225BL - Troubleshooting and Support; Problem Solver Guide

THE E~UST mA_
(continued)
Charcoal Ftiter fit (for some models)
There is a Recirculating Charcoal Filter Kit available for models that are not vented
to the outside. Filter Kit model JX81A can be ordered horn your Hotpoint supplier.
Ask for part
~02X9883.
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
POSS~LE CAUSE
omm.~o~
● A~%.kyow @me maybe blown or tie circuit breaker trippd Repke fuse or
CO~.ON : .: met circuit bre&er.
● Unp~ug your ~owave oien, then plug it back in.
.s:M@ $~ ~-~rong Plug ~n oven iS my inserted into wti reCep&Cle.
C~~OLP=
*Door fiot =ely ‘closed.
LIGm, m~ Ow
* ST~T pad must be touchd after entering cooking sdection.
-NOT START
s kothti selection entered tieady in oven and CLWWOPF pad not touched to
cancel it.
● Make sure you have entered cooting time after to~ching ~ COOK pad.
s CLEWO~ pad w=touchd accidentiy. Reset cooking program and touch
ST~Tpad.
FLOOR OF= OW
● The -ktop 1- is located directiy below tie oven floor. -n thelamp
IS WW,:E~ :
ison~tie heat it prduces makes the oven floor getwarrn. This is Ro@ :
~m Om
HAS NOT BWUSED ,
AM tiese things are normal with your microwave oven:
● Steam or vapor escaping from around the door.
● Dull thumping sound while oven is operating.
● Light reflection around door or outer case.
● Some W-Radio interference might be noticed
● Dimming oven light and change in blower sound
while using your microwave oven. It’s similar to
may occur while operating at power levels other
the interference caused by other small appliances
than high.
and does not indicate a problem with your oven.
mu need more help...cdl, to~ free: GE Answer Center” / 800.6262000 / consumer information service
26