Keep your oven clean and sweet- Don’t use sharp-edged
utens~
smelling.
Opening the oven door on your oven.
The
inside and
a few minutes after cooking helps outside oven walls can be
air
out the inside. An occasional
scratched. The control panel
thorough wiping with a solution
can be damaged.
of baking soda and water keeps
the inside fresh.
BE
CERTA~
POWER IS
0~
BEFORE CLEANING ANY
PART OF
T~S
OWN.
How to Clean the
Imide
Walls and floor.
Some spatters can be removed
witi a paper towel, others may require a damp cloth.
Remove greasy spatters with a
sudsy
cloth, then rinse
with a damp cloth. Do not use abrasive cleaners on
oven walls.
~VER
USE A
COM~RCW
OVEN
CLE~R
ON ANY PART OF YOUR
MICROWAVE OVEN.
Door (inside).
Window: Wipe up spatters daily
and wash when soiled with a damp cloth. Rinse
thoroughly and dry.
Metal and plastic parts on door: Wipe frequently
with a damp cloth to remove
dl
soil. DO NOT USE
ABWSIVES,
SUCH AS
CLEmG
POWDERS
OR STEEL AND PLASTIC PADS. THEY
WL
DAMAGE
THE
SURFACE.
Specird
note when using Brown ‘N Sear Dish:
If
grease is present, high heat generated on bottom of
a Brown ‘N Sear dish may cause the grease to bum
onto the oven tray. This may be removed with a
cleanser such as Bon
Ami@
brand cleanser.
After using Bon
Arni@
brand cleanser, rinse and dry
thoroughl
, following instructions on can. Do not use
J
Bon
Am
brand cleanser on the painted surfaces such
as the walls. It may scratch the paint.
How to Clean the
Ouhide
Case. Clean the outside of your oven with soap
and
damp cloth, rinse with a damp cloth and then dry.
Wipe the window clean with a damp cloth. Chrome
trim is best wiped with a damp cloth and then with
a
dry
towel.
Control Panel. Wipe with a damp cloth. Dry
thoroughly. Do not use cleaning sprays, large amounts
of soap and water, abrasives or sharp objects on the
panel-they can damage it.
Door Surface.
When cleaning surfaces of door and
oven that come together on closing the door, use only
mild, non-abrasive soaps or detergents applied with a
sponge or soft cloth.
Power Cord.
If the cord becomes soiled, unplug and
wash with a damp cloth. For stubborn spots,
sudsy
water may be used, but be certain to rinse with a
damp cloth and dry thoroughly before plugging cord
into outlet.
23
To Next Page
Loading...
