This appliance must be grounded.
k
the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This
apptiance
is equipped with a
power cord having a grounding
wire with a grounding plug.
The
PREFERRED
METHOD
n
Qm
+
Ensure proper ground
Fia.
1
exists before use
plug must be plugged into
an
outlet
L
-
that is properly instiled and
Consult a
audified
elecrncian
or
mere
a standard 2-prong wdl
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded 3-prong
wdl
receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
grounded.-(Fig.
1)
service
tectician
if the grounding
WARN~G–ImproWr
instructions are not completely
this
appfiance.
- - -
understood, or if doubt exists as to
Do
not use an
etiension
cord
use
of the
gounding
Plug
can
whether the appliance is properly
with this appliance.
result in a
fisk
of
el~~tic-shock.
grounded.
w
,.
..-.,-.,
.,..;2;’
“.:
.,.,
The
e~ust
hood
feature on your microwave oven is equipped with two
meti
filters which collect grease.
men
the fan is operated, air is drawn
up through
the
falters and is then discharged through the provided venting
to the outside.
METAL
I
MtiAL
FILTER
coo~op
FILTER
LIGHT
Remable
Grease Filters
The grease
filters should be cleaned at least once a month. Never
operate the microwave without the filters in place. In situations where
flaming might occur on surfaces below hood, filters will stop the entry
of flames into the unit.
To Remove Grease
Ftiter
To Clean and Replace Grease
Ftiter
To remove
grease
f~ter,
To clean grease falter, soak it
ad
then
agitate filter
grasp the “finger hold”
in solution of hot water and detergent. Don’t use
on the filter and slide to
-onia
or ammonia products because they
wdl
the rear.
men
pull filter
darken the metal. Light brushing can be used to
downwad and to the
remove embedded dirt.
front.
The
filter will
drop out.
Wse,
shake and remove moisture before replacing.
To replace
grwe
filter, slide the
filter
in the frame
slot on the back of the opening.
Pull filter upward and to the front to lock into place.
(continued
ne~page)
25
To Next Page
Loading...
