Hybrid/AC-coupled Inverter User Manual
© 2024 Hoymiles Power Electronics Inc. All rights reserved.
04
This side up! This package must always be transported, handled, and stored in
such a way that the arrows always point upwards.
Fragile - The package/product should be handled carefully and should never be
tipped over or slung.
Keep dry! The package/product must be protected from excessive humidity
and must be stored under cover.
No more than six (6) identical packages are to be stacked on each other.
1.2 Safety Information
This chapter contains important safety and operating instructions. For future reference, please read and
keep this manual.
For the purpose of preventing personal injury and property damage, as well as ensuring the long-term
operation of the product, please read and follow all the instructions and cautions on the inverter and in this
user manual during installation, operation, and maintenance.
Safety instructions in this manual cannot cover all precautions that should be taken. Please consider the
actual conditions on site when performing operations. Any damage caused by a violation of the safety
instructions in this manual shall not be the responsibility of Hoymiles.
Symbol Usage
Danger to life from electric shock
• Before performing any work on the inverter, disconnect all DC and AC power
from the inverter and wait for at least 10 minutes. Hazardous voltage will
exist for up to 10 minutes after disconnection from the power supply.
• Never insert or remove the AC or DC connections when the inverter is
running.
• Any live parts connected to battery ports cannot be touched before removing
all the power from the inverter for 10 minutes because there is still danger to
life even battery voltage is lower than 60 V.
• Do not touch DC conductors or any non-isolated cable ends.
• The mounting location must be inaccessible to children.
• Never touch either the positive or negative pole of the PV connecting device.
Strictly prohibit touching both at the same time.
Risk of burns from hot surfaces
• The surface of the inverter might exceed 60
℃
, and touching the surface may
result in burns.
• Do not touch hot surfaces before the inverter cools down.
DANGER
6
WARNING
To Next Page
Loading...
