HP 10500 series

114
Ste
p
Command Remarks
4. Configure the tunnel setup
retry interval.
mpls te timer retry seconds
Optional.
The default is 2 seconds.
5. Submit current tunnel
configuration.
mpls te commit N/A
Assigning priorities to a tunnel
Two priorities, setup priority and holding priority, are assigned to paths for MPLS TE to make preemption
decision. For a new path to preempt an existing path, the setup priority of the new path must be greater
than the holding priority of the existing path.
To avoid flapping caused by improper preemptions between CR-LSPs, the setup priority of a CR-LSP must
not be set higher than its holding priority.
To assign priorities to a tunnel:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Assign priorities to the tunnel.
mpls te priority setup-priority
[ hold-priority ]
Optional.
The default setup and holding
priorities are 7.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring traffic forwarding
This section describes how to forward traffic through MPLS TE tunnels.
Before you configure traffic forwarding, complete the following tasks:
• Configure basic MPLS.
• Configure basic MPLS TE.
• Configure MPLS TE tunnels.
Forwarding traffic along MPLS TE tunnels using static routes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A