HP 10500 series

199
Task Remarks
Configuring basic MPLS L2VPN
Required.
Perform this task to enable MPLS L2VPN. You can
perform other MPLS L2VPN configurations only after
you enable MPLS L2VPN.
Configuring a PE-CE interface
Required.
Perform this task to set up an AC between a PE and a
CE.
Configuring CCC MPLS L2VPN
Use one of the approaches according to the MPLS
L2VPN implementation method.
Perform this task to set up a VC, and bind the VC to an
AC.
Configuring SVC MPLS L2VPN
Configuring Martini MPLS L2VPN
Configuring Kompella MPLS L2VPN
Configuring basic MPLS L2VPN
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the LSR ID.
mpls lsr-id lsr-id N/A
3. Configure basic MPLS and
enter MPLS view.
mpls N/A
4. Return to system view.
quit N/A
5. Enable L2VPN and enter
L2VPN view.
l2vpn Disabled by default.
6. Enable MPLS L2VPN.
mpls l2vpn Disabled by default.
Configuring a PE-CE interface
A PE-CE interface refers to the PE's interface connected to a CE.
As shown in Table 2, a P
E-CE interface can use various types of encapsulations.
Table 2 Encapsulation types on a PE-CE interface of a PE
Enca
p
sulation t
yp
e Confi
g
uration
Ethernet Configuring Ethernet encapsulation
VLAN Configuring VLAN encapsulation
Configuring Ethernet encapsulation
Martini MPLS L2VPN configuration for a service instance allows you to configure an encapsulation type
for a PE-CE interface while other types of MPLS L2VPN require a PE-CE interface to use the default
encapsulation type.