HP 10500 series

141
[SwitchA-mpls] mpls rsvp-te
[SwitchA-mpls] quit
[SwitchA] interface vlan-interface 12
[SwitchA-Vlan-interface12] mpls
[SwitchA-Vlan-interface12] mpls te
[SwitchA-Vlan-interface12] mpls rsvp-te
[SwitchA-Vlan-interface12] mpls rsvp-te bfd enable
[SwitchA-Vlan-interface12] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] mpls lsr-id 2.2.2.2
[SwitchB] mpls
[SwitchB-mpls] mpls te
[SwitchB-mpls] mpls rsvp-te
[SwitchB-mpls] quit
[SwitchB] interface vlan-interface 12
[SwitchB-Vlan-interface12] mpls
[SwitchB-Vlan-interface12] mpls te
[SwitchB-Vlan-interface12] mpls rsvp-te
[SwitchB-Vlan-interface12] mpls rsvp-te bfd enable
[SwitchB-Vlan-interface12] quit
2. Configure OSPF:
# Configure Switch A.
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 12.12.12.1 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 12.12.12.2 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
3. Configure IP addresses for the interfaces:
# Configure Switch A.
[SwitchA] interface vlan-interface 12
[SwitchA-Vlan-interface12] ip address 12.12.12.1 24
[SwitchA-Vlan-interface12] quit
# Configure Switch B.
[SwitchB] interface vlan-interface 12
[SwitchB-Vlan-interface12] ip address 12.12.12.2 24
4. Configure an RSVP-TE tunnel between Switch A and Switch B.
[SwitchA] interface tunnel 1
[SwitchA-Tunnel1] ip address 10.10.10.1 24