HP 10500 series - Page 160

152
# Execute the display mpls te tunnel-interface command on Switch A to view the configuration of
the tunnel interface.
[SwitchA] display mpls te tunnel-interface
Tunnel Name : Tunnel4
Tunnel Desc : Tunnel4 Interface
Tunnel State Desc : Modifying CR-LSP is setting up
Tunnel Attributes :
LSP ID : 1.1.1.1:1
Session ID : 10
Admin State : UP Oper State : UP
Ingress LSR ID : 1.1.1.1 Egress LSR ID: 4.4.4.4
Signaling Prot : RSVP Resv Style : SE
Class Type : CT0 Tunnel BW : 0 kbps
Reserved BW : 0 kbps
Setup Priority : 7 Hold Priority: 7
Affinity Prop/Mask : 0x0/0x0
Explicit Path Name : pri-path
Tie-Breaking Policy : None
Metric Type : None
Record Route : Enabled Record Label : Enabled
FRR Flag : Enabled BackUpBW Flag: Not Supported
BackUpBW Type : - BackUpBW : -
Route Pinning : Disabled
Retry Limit : 10 Retry Interval: 10 sec
Reopt : Disabled Reopt Freq : -
Back Up Type : None
Back Up LSPID : -
Auto BW : Disabled Auto BW Freq : -
Min BW : - Max BW : -
Current Collected BW: -
Interfaces Protected: -
VPN Bind Type : NONE
VPN Bind Value : -
Car Policy : Disabled
Tunnel Group : Primary
Primary Tunnel : -
Backup Tunnel : -
Group Status : -
Tunnel Name : Tunnel4
Tunnel Desc : Tunnel4 Interface
Tunnel State Desc : Modifying CR-LSP is setting up
Tunnel Attributes :
LSP ID : 1.1.1.1:1025
Session ID : 10
Admin State : Oper State : Modified
Ingress LSR ID : 1.1.1.1 Egress LSR ID: 4.4.4.4
Signaling Prot : RSVP Resv Style : SE