HP 10500 series - Page 40

32
[MCE2-Vlan-interface101] quit
# Create the tunnel interface Tunnel0.
[MCE2] interface tunnel 0
# Configure an IP address for the Tunnel0 interface.
[MCE2-Tunnel0] ip address 10.1.1.2 255.255.255.0
# Specify the tunnel protocol as GRE.
[MCE2-Tunnel0] tunnel-protocol gre
# Specify the source address of the tunnel.
[MCE2-Tunnel0] source vlan-interface 100
# Specify the destination address of the tunnel.
[MCE2-Tunnel0] destination 192.168.1.1
[MCE2-Tunnel0] quit
# Create loopback group 1 and specify its service type as tunnel.
[MCE2] service-loopback group 1 type tunnel
# Add any unused port (GigabitEthernet 1/0/3 in this example) to loopback group 1.
[MCE2] interface GigabitEthernet 1/0/3
[MCE2-GigabitEthernet1/0/3] undo stp enable
[MCE2-GigabitEthernet1/0/3] port service-loopback group 1
# Reference loopback group 1 on the tunnel interface.
[MCE2-GigabitEthernet1/0/3] quit
[MCE2] interface tunnel 0
[MCE2-Tunnel0] service-loopback-group 1
[MCE2-Tunnel0] quit
# Create the tunnel interface Tunnel1.
[MCE2] interface tunnel 1
# Configure an IP address for the Tunnel 1 interface.
[MCE2-Tunnel1] ip address 10.1.2.2 255.255.255.0
# Specify the tunnel protocol as GRE.
[MCE2-Tunnel1] tunnel-protocol gre
# Specify the source address of the tunnel.
[MCE2-Tunnel1] source vlan-interface 101
# Specify the destination address of the tunnel.
[MCE2-Tunnel1] destination 192.168.2.1
# Reference loopback group 1 on the tunnel interface.
[MCE2-Tunnel1] service-loopback-group 1
2. Configure VPN instances on MCE 1:
# Create VPN instance vpn1 for VPN 1, and configure an RD for it.
<MCE1> system-view
[MCE1] ip vpn-instance vpn1
[MCE1-vpn-instance-vpn1] route-distinguisher 1:2
[MCE1-vpn-instance-vpn1] vpn-target 1:2
[MCE1-vpn-instance-vpn1] quit
# Create VPN instance vpn2 for VPN 2, and configure an RD for it.
[MCE1] ip vpn-instance vpn2
[MCE1-vpn-instance-vpn2] route-distinguisher 1:3