HP 10500 series User Manual

86
# Configure MPLS and MPLS LDP on Switch A.
[SwitchA] mpls lsr-id 1.1.1.9
[SwitchA] mpls
[SwitchA-mpls] quit
[SwitchA] mpls ldp
[SwitchA-mpls-ldp] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] mpls
[SwitchA-Vlan-interface2] mpls ldp
[SwitchA-Vlan-interface2] quit
# Configure MPLS and MPLS LDP on Switch B.
[SwitchB] mpls lsr-id 2.2.2.9
[SwitchB] mpls
[SwitchB-mpls] quit
[SwitchB] mpls ldp
[SwitchB-mpls-ldp] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] mpls
[SwitchB-Vlan-interface2] mpls ldp
[SwitchB-Vlan-interface2] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] mpls
[SwitchB-Vlan-interface3] mpls ldp
[SwitchB-Vlan-interface3] quit
# Configure MPLS and MPLS LDP on Switch C.
[SwitchC] mpls lsr-id 3.3.3.9
[SwitchC] mpls
[SwitchC-mpls] quit
[SwitchC] mpls ldp
[SwitchC-mpls-ldp] quit
[SwitchC] interface vlan-interface 3
[SwitchC-Vlan-interface3] mpls
[SwitchC-Vlan-interface3] mpls ldp
[SwitchC-Vlan-interface3] quit
After the configuration is complete, two local LDP sessions are established, one between Switch A
and Switch B and the other between Switch B and Switch C.
# Execute the display mpls ldp session command on each switch to view the LDP session
information, and execute the display mpls ldp peer command to view the LDP peer information.
Take Switch A as an example:
[SwitchA] display mpls ldp session
LDP Session(s) in Public Network
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID Status LAM SsnRole FT MD5 KA-Sent/Rcv
----------------------------------------------------------------
2.2.2.9:0 Operational DU Passive Off Off 5/5
----------------------------------------------------------------
LAM : Label Advertisement Mode FT : Fault Tolerance

HP 10500 series Specifications

General

Brand	HP
Model	10500 series
Category	Switch
Language	English