HP 10500 series

89
Local Discr : 130 Remote Discr : 130
Tunnel ID : --- NextHop : ---
Session State : Up Source IP : 3.3.3.9
Session Role : Passive
FEC : 21.1.1.0/24 Type : LSP
Local Discr : 129 Remote Discr : 129
Tunnel ID : 0x6040000 NextHop : 10.1.1.2
Session State : Up Source IP : 1.1.1.9
Session Role : Active
Total Session Num: 2
The output shows that two BFD sessions have been established between Switch A and Switch C:
one for testing the connectivity of the LSP Switch A-Switch B-Switch C, and the other for testing the
connectivity of the LSP Switch C-Switch B-Switch A.
# Use the display bfd session verbose command to view detailed information about BFD sessions:
[SwitchA] display bfd session verbose
Total session number: 2 Up session number: 2 Init mode: Active
IPv4 session working under Ctrl mode:
Local Discr: 129 Remote Discr: 129
Source IP: 1.1.1.9 Destination IP: 127.0.0.1
Session State: Up Interface: LoopBack0
Min Trans Inter: 400ms Act Trans Inter: 400ms
Min Recv Inter: 400ms Act Detect Inter: 2000ms
Running Up for: 00:15:52 Auth mode: None
Connect Type: Indirect Board Num: 6
Protocol: MFW/LSPV
Diag Info: No Diagnostic
Local Discr: 130 Remote Discr: 130
Source IP: 1.1.1.9 Destination IP: 3.3.3.9
Session State: Up Interface: LoopBack0
Min Trans Inter: 400ms Act Trans Inter: 400ms
Min Recv Inter: 400ms Act Detect Inter: 2000ms
Running Up for: 00:15:44 Auth mode: None
Connect Type: Indirect Board Num: 7
Protocol: MFW/LSPV
Diag Info: No Diagnostic