HP 1650B User Manual

AUToscale
AUToscale
command
The AUToscale command causes the current analyzer (machine) to
autoscale if the current machine is a timing analyzer. If the current
machine is not a timing analyzer, the AUToscale command is ignored.
AUToscale is an Overlapped Command. Overlapped Commands allow
execution of subsequent commands while the logic analyzer operations
initiated by the Overlapped Command are still in progress. Command
overlapping can be avoided by using the *OPC and *WAI commands (see
the chapter “Common Commands”) in conjunction with AUToscale.
4
Note @
Command Syntax:
Example:
MACHine Subsystem
10-6
When the AUToscale command is issued, existing timing analyzer
configurations are erased and the other analyzer is turned off.
:MACHine{ 1 IP}:AUToscale
OUTPUT XXX;":MACHINEl:AUTOSCALE"
HP 1650B/HP 16518
Programming Reference

HP 1650B Specifications

General

Brand	HP
Model	1650B
Category	Measuring Instruments
Language	English