HP 1650B

OTAG
OTAG command/query
The OTAG command specifies the tag value on which the 0 Marker
should be placed. The tag value is time when time tagging is on or states
when state tagging is on. If the data is not valid tagged data, no action is
performed.
The OTAG query returns the 0 Marker position in time when time
tagging is on or in states when state tagging is on, regardless of whether
the marker was positioned in time or through a pattern search. If data is
not valid, the query returns 9.9E37 for time tagging, 32767 for state
tagging.
Command Syntax: :MACHine{lj2):SLlSt:OTAG {<time-value> 1 <state-valuer)
where:
c time-value z- :: = real number
<state-value > :: = integer
Example: :OUTPUT XXX;":MACHINEl:SLIST:OTAG 40.OE-6"
Query Syntax:
:MACHine{l j2}:SLISt:OTAG?
Returned Format: [:MACHine{l j2):SLISt:OTAGJ {<time-value > I <state-value z-1 < NL>
Example: 10 DIM Ot$[lOO]
20 OUTPUT XXX;“:MACHINE1:SLIST:OTAG?”
30 ENTER XXX;Ot$
40 PRINT Ot$
50 EN0
HP 1650B/HP 16518
Programming Reference
SLIST Subsystem
13-15