INSert
INSert
command
The INSert command inserts waveforms in the timing waveform display.
The waveforms are added from top to bottom. When 24 waveforms are
present, inserting additional waveforms replaces the last waveform .
The first parameter specifies the label name that will be inserted. The
second parameter specifies the label bit number or overlay.
If
OVERlay
is specified, all the bits of the label are displayed as a
composite overlaid waveform.
Command Syntax:
:MACHine{
1
IP}:TWAVeform:INSert
c
label-name
z-
,{
c
bit-id
z=
)
OVERlay}
where:
c label-name
z=
:: = string of up to 6 alphanumeric characters
<bit
id
>
:: = integer from 0 to 31
Example:
OUTPUT
XXX;":MACHINEl:TWAVEFORM:INSERT,
'WAVE',lO"
TWAVeform Subsystem
19-8
HP
1850B/HP
18518
Programming Reference
To Next Page
Loading...
