HP 166207-B21 - Smart Array 5302/32 RAID Controller - ACU Scripting Error Messages

HP Array Configuration Utility 87
Warning
code
Warning message Comment or clarification
4002 Chassis name is already set to this value
The chassis name is already set to the supplied
value. The command is ignored.
4003
One or more controller commands were
skipped because the controller is not
configured
Certain commands require that the controller be
configured before they can be sent to the
controller.
4004 Using Repeat function
Some commands have been ignored because
the Repeat parameter has been specified in the
input file.
ACU scripting error messages
Error
code
Error message Comment or clarification
0 —
No error exists. The program completed
successfully.
2053
Too many coinciding expansion,
migration, or extension operations
The new configuration requires more
transformations than are possible at one time. For
example, you cannot expand a logical volume
and transform its RAID level at the same time.
2056 Controller does not support license keys
The controller does not support license key entry
or deletion.
2059 Invalid license key The entered license key is not a valid license key.
2064 Controller does not support SSP The controller does not support SSP functions.
2817 Invalid Action
The requested actions are invalid, for example,
combining
-reset
with capture mode.
2818 Invalid Method The method must be either Custom or Auto.
2819 Invalid Controller An invalid controller value was specified.
2821 No controllers detected
No controllers were detected. This error applies to
Input mode only.
2823 Invalid Rebuild Priority The specified rebuild priority is not supported.
2824 Invalid Expand Priority
The specified expand priority is not supported.
This error also occurs if the controller does not
allow expansion, and therefore, does not support
expand priority.
2825 Invalid Array The array ID is invalid.
2826 Array not specified
The Array command is missing from the script file.
Some commands were found that require an
Array to be specified.
2827
New Array ID does not match the next
available Array ID.
The array ID in the script file does not match the
array ID of the next available array. For example,
if the configuration has an Array A and the input
file specifies Array C (without Array B), then the
script generates this error.
2828 New Array ID already exists
The array ID specified in the script file (in
Configure mode) already exists in the