c. Remove the display hinges (3).
The display hinges are available using spare part number N86632-001.
d. To remove the hinge covers, remove the Phillips M2.0 × 2.0 screw (1) from each cover, and then
remove the covers (2).
The display hinge covers are available using spare part number N93769-001.
11. To remove the camera module:
a. Insert a tool at the two locations (1) shown in the following illustration.
NOTE: Be sure to insert the tool at the locations shown in the following illustration. These
locations are reinforced with metal to prevent damage during removal.
b. Carefully lift the module (2) to release it from the display back cover. The module is attached
with double-sided adhesive.
c. Turn the module over, and then disconnect the cable from the ZIF connector (3) on the module.
Note that the cable routes underneath the module.
The camera module is available as spare part number N86659-001.
Display assembly
53
To Next Page
Loading...
