d. Remove the cable from the clips (4) at the bottom of the display rear cover.
The display cable is available as spare part number N86639-001 for models with an OLED
display and N86640-001 for models with an FHD display.
15. To remove the WLAN antennas:
a. Remove the wireless antenna cables (1) from the hinge.
b. Lift up the ESD tape (2) that secures the cables to the display rear cover.
c. Remove the antenna cables (3) from the routing on the inside of the display rear cover.
d. Peel the wireless antennas (4) off the display rear cover. The antennas are attached
with double-sided adhesive. The wireless antennas are available using spare part number
N86634-001.
The display back cover with dual antennas is available using spare part number N93766-001.
To reassemble and replace the display assembly, reverse these procedures.
56
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
