HP 250 - Page 101

Graphics Devices
3. Press the new pen into the holder while still holding the
carrier ring with the other hand. See the illustration
below.
4. Re-enable the plotter by turning off the CHART LOAD lamp.
You should put a cap on the pen after the plotting session
is terminated.
Four and Eight Pen Plotters:
1. Disable the plotter by turning on the STANDBY lamp.
2. Push the PEN SELECT pushbutton for the stall to be
loaded. The old pen will be placed in the pen holder.
3. Remove the old pen from the pen holder.
4. Load the new pen into the pen holder, as shown in the
figure below.
5. Push the ENTER and appropriate PEN SELECT (1-8) push-
buttons in sequence. The pen will be loaded into the
selected stall.
6. Repeat the operation for any other pens to be changed.
7. It is recommended that stalls 1 through 4 be loaded with
narrow line paper pens, black, red, green, and blue,
respectively.
8. Set the ON LINE lamp to the blinking state when ready to
continue plotting. The STANDBY lamp should turn off
automatically.
9. After finishing plotting, be sure that all pens are in the
stalls. If one remains in the pen holder, it may dry out.
To return it to the holder, push ENTER and the appropriate
PEN SELECT (1-8) pushbutton.
7-6
Graphics Devices
3. Press the new pen into the holder while still holding the
carrier ring with the other hand. See the illustration
below.
4. Re-enable the plotter by turning off the CHART LOAD lamp.
You should put a cap on the pen after the plotting session
is terminated.
Four and Eight Pen Plotters:
1. Disable the plotter by turning on the STANDBY lamp.
2. Push the PEN SELECT pushbutton for the stall to be
loaded. The old pen will be placed in the pen holder.
3. Remove the old pen from the pen holder.
4. Load the new pen into the pen holder, as shown in the
figure below.
5. Push the ENTER and appropriate PEN SELECT (1-8) push-
buttons in sequence. The pen will be loaded into the
selected stall.
6. Repeat the operation for any other pens to be changed.
7. It is recommended that stalls 1 through 4 be loaded with
narrow line paper pens, black, red, green, and blue,
respectively.
8. Set the ON LINE lamp to the blinking state when ready to
continue plotting. The STANDBY lamp should turn off
automatically.
9. After finishing plotting, be sure that all pens are in the
stalls. If one remains in the pen holder, it may dry out.
To return it to the holder, push ENTER and the appropriate
PEN SELECT (1-8) pushbutton.
7-6