HP 250 - Loading from a Flexible Disc Drive

System Start-up
If no problem occurs, a message in the form:
SYSTFM LOADING
followed by:
LOADING DROMS
is shown. The message remains on the screen for about ten sec-
onds. A blinking underscore, known as the cursor, appears on the
display to indicate completion of the loading process.
Loading from a Flexible Disc Drive
The following is the procedure for loading your HP 250 system
from the flexible disc drive.
1. Open the drive door by pressing the small bar on the drive.
Insert the disc labeled SYSTEM into the drive until the disc
clicks into place. Pull the drive door down so that it
latches.
2. Insert the key and turn it clockwise to position 1. The
drive door is locked automatically during loading. If the
light indicating that the drive is in use never comes on, it
may mean that the disc was inserted improperly. Open the
drive door and remove the disc; retry the procedure.
2-4
System Start-up
If no problem occurs, a message in the form:
SYSTFM LOADING
followed by:
LOADING DROMS
is shown. The message remains on the screen for about ten sec-
onds. A blinking underscore, known as the cursor, appears on the
display to indicate completion of the loading process.
Loading from a Flexible Disc Drive
The following is the procedure for loading your HP 250 system
from the flexible disc drive.
1. Open the drive door by pressing the small bar on the drive.
Insert the disc labeled SYSTEM into the drive until the disc
clicks into place. Pull the drive door down so that it
latches.
2. Insert the key and turn it clockwise to position 1. The
drive door is locked automatically during loading. If the
light indicating that the drive is in use never comes on, it
may mean that the disc was inserted improperly. Open the
drive door and remove the disc; retry the procedure.
2-4