HP 250 - HP 2608 A Printer; Operator Safety; Loading and Adjusting Paper

HP 2608 Printer
HP 2608A Printer
The HP 2608 Dot Matrix Printer forms characters by printing a
pattern of inked dots. The maximum speed of the HP 2608 is 400
lines per minute.
Operator Safety
Close the access cover when the printer is in a ready-to-operate
condition and when it is operating. Keep hands, long hair,
necklaces and articles of clothing such as long sleeves out of
the printer when ready-to-operate or operating conditions exist.
Loading and Adjusting Paper
The HP 2608A will accommodate continuous fan-fold edge-perforated
paper. It will accommodate forms thickness variations up to a
total pack thickness of 0.61 mm (0.025 inches). Forms thicker
than 0.61 mm should be tested to verify that they will print
successfully. Recommended paper weights are: 15 to 20 pounds
single part and 11 pounds multi-part forms. Forms and card stock
should be tried for satisfactory feeding, registration, and print
quality. Multi-part forms must be held together without the use
of metal or plastic fasteners.
6-5
HP 2608 Printer
HP 2608A Printer
The HP 2608 Dot Matrix Printer forms characters by printing a
pattern of inked dots. The maximum speed of the HP 2608 is 400
lines per minute.
Operator Safety
Close the access cover when the printer is in a ready-to-operate
condition and when it is operating. Keep hands, long hair,
necklaces and articles of clothing such as long sleeves out of
the printer when ready-to-operate or operating conditions exist.
Loading and Adjusting Paper
The HP 2608A will accommodate continuous fan-fold edge-perforated
paper. It will accommodate forms thickness variations up to a
total pack thickness of 0.61 mm (0.025 inches). Forms thicker
than 0.61 mm should be tested to verify that they will print
successfully. Recommended paper weights are: 15 to 20 pounds
single part and 11 pounds multi-part forms. Forms and card stock
should be tried for satisfactory feeding, registration, and print
quality. Multi-part forms must be held together without the use
of metal or plastic fasteners.
6-5