HP 250 - Remote Keys; Softkeys

HP 2622D Personal Workstation
Remote Keys
The remote keys, labeled RESUME, E3 , and TEST, are located in
the upper left hand corner of the keyboard.
El
Softkeys
The RESUME key allows you to request a total update of
display information in the event of a data communication
or other error that would cause the workstation to
display incorrect data. When you press this key, the
display storage area is erased and the remote workstation
display is rewritten under the control of the HP 250
system.
NOTE
Pressing RESilllE while data is being
sent to a remote printer results in
a loss of the data.
The TEST key initiates several diagnostic tests to verify
the workstation's operation. The self-test is performed
on a local basis; in other words, the test is performed
even if the remote workstation is not connected to the HP
250. These diagnostic tests are described later in this
section under the heading "Testing the HP 2622D"
The MODEM key is a local key that is significant when you
are linked to the HP 250 system via a modem. It can be
set as either active or inactive in the terminal
configuration (see "Setting the HP 2622D Configuration").
When configured as active, pressing this key disconnects
the modem; pressing it again connects the modem. You can
see the status of this key by accessing the Status
Display, as described on page 3-12.
There are eight softkeys located on the top portion of the
keyboard.
You will most likely use these keys in conjunction with an
application software program, a utility program (such as
initializing media), or as typing aids; these are known as
user-defined softkeys.
3-8
HP 2622D Personal Workstation
Remote Keys
The remote keys, labeled RESUME, E3 , and TEST, are located in
the upper left hand corner of the keyboard.
El
Softkeys
The RESUME key allows you to request a total update of
display information in the event of a data communication
or other error that would cause the workstation to
display incorrect data. When you press this key, the
display storage area is erased and the remote workstation
display is rewritten under the control of the HP 250
system.
NOTE
Pressing RESilllE while data is being
sent to a remote printer results in
a loss of the data.
The TEST key initiates several diagnostic tests to verify
the workstation's operation. The self-test is performed
on a local basis; in other words, the test is performed
even if the remote workstation is not connected to the HP
250. These diagnostic tests are described later in this
section under the heading "Testing the HP 2622D"
The MODEM key is a local key that is significant when you
are linked to the HP 250 system via a modem. It can be
set as either active or inactive in the terminal
configuration (see "Setting the HP 2622D Configuration").
When configured as active, pressing this key disconnects
the modem; pressing it again connects the modem. You can
see the status of this key by accessing the Status
Display, as described on page 3-12.
There are eight softkeys located on the top portion of the
keyboard.
You will most likely use these keys in conjunction with an
application software program, a utility program (such as
initializing media), or as typing aids; these are known as
user-defined softkeys.
3-8