HP 250 - Turfiingon~Ac Power

Graphics Devices
In this chapter, you will learn how to operate an HP Graphics
Plotter.
The instructions from this chapter are a simplified version of
those available from the Operating and Programming Manuals
supplied with HP Graphics Plotters. More details and pictures
may be found in the manual supplied with your plotter.
To proceed further, you should have one of the following plotters
connected to your system:
Single Pen Plotter
HP 7225A/7225B Graphics Plotter with either
option 17603A RS-232-C Personality Module
or
option 17604A RS-232-C Personality Module
Four Pen Plotter
HP 7220A/7221A/7221B Graphics Plotter
HP 72208/7221S Graphics Plotter
with automatic paper advance
Eight Pen Plotter
HP 7220C/7221C Graphics Plotter
HP 7220T/7221T Graphics Plotter
with automatic paper advance
Turning on AC Power
If the device has never been connected to your power line, be
sure it is properly configured for your type of AC Power BEFORE
plugging it in. See the plotter Operating and Programming Manual
for details.
1. Locate the Power Switch
Single Pen Plotters - Located on the right hand side near
the base of the plotter.
Four and Eight Pen Plotters - Located under the right front
edge near the base.
7-3
Graphics Devices
In this chapter, you will learn how to operate an HP Graphics
Plotter.
The instructions from this chapter are a simplified version of
those available from the Operating and Programming Manuals
supplied with HP Graphics Plotters. More details and pictures
may be found in the manual supplied with your plotter.
To proceed further, you should have one of the following plotters
connected to your system:
Single Pen Plotter
HP 7225A/7225B Graphics Plotter with either
option 17603A RS-232-C Personality Module
or
option 17604A RS-232-C Personality Module
Four Pen Plotter
HP 7220A/7221A/7221B Graphics Plotter
HP 72208/7221S Graphics Plotter
with automatic paper advance
Eight Pen Plotter
HP 7220C/7221C Graphics Plotter
HP 7220T/7221T Graphics Plotter
with automatic paper advance
Turning on AC Power
If the device has never been connected to your power line, be
sure it is properly configured for your type of AC Power BEFORE
plugging it in. See the plotter Operating and Programming Manual
for details.
1. Locate the Power Switch
Single Pen Plotters - Located on the right hand side near
the base of the plotter.
Four and Eight Pen Plotters - Located under the right front
edge near the base.
7-3