HP 250 - Starting up the HP 7906

Storage Devices and Media
Starting Up the HP 7906
To operate the HP7906, proceed as follows:
1) Set the RUN/STOP switch to the STOP position.
2) Push in on the bottom edge of the control panel access door
to open it.
3) Set the POWER/OFF switch to POWER position and observe that
the Unit Select Identification and DOOR UNLOCKED indicators
light (Note that some HP 7906 models have the power switch
on the rear panel).
4) Close the control panel access door.
5) Open the cartridge access door by pulling out and down on its
recessed upper edge.
CAUTION
If head and disc contact should occur, as
described earlier, do not attempt to re-
trieve data by placing a potentially dam-
aged disc cartridge in another drive.
Also, do not place another disc cartridge
in this drive until the drive and disc
cartridge have been checked by service-
trained personnel.
6) Carefully insert an HP 12940A Formatted Disc Cartridge,
access-door end first, until it is seated fully.
7) Close the cartridge access door.
8) Set the RUN/STOP switch to RUN. The DOOR UNLOCKED indicator
will go out and after the startup sequence is complete (one
minute or less), the DRIVE READY indicator will light. The
DRIVE FAULT indicator will only light if a malfunction
occurs.
5-11
Storage Devices and Media
Starting Up the HP 7906
To operate the HP7906, proceed as follows:
1) Set the RUN/STOP switch to the STOP position.
2) Push in on the bottom edge of the control panel access door
to open it.
3) Set the POWER/OFF switch to POWER position and observe that
the Unit Select Identification and DOOR UNLOCKED indicators
light (Note that some HP 7906 models have the power switch
on the rear panel).
4) Close the control panel access door.
5) Open the cartridge access door by pulling out and down on its
recessed upper edge.
CAUTION
If head and disc contact should occur, as
described earlier, do not attempt to re-
trieve data by placing a potentially dam-
aged disc cartridge in another drive.
Also, do not place another disc cartridge
in this drive until the drive and disc
cartridge have been checked by service-
trained personnel.
6) Carefully insert an HP 12940A Formatted Disc Cartridge,
access-door end first, until it is seated fully.
7) Close the cartridge access door.
8) Set the RUN/STOP switch to RUN. The DOOR UNLOCKED indicator
will go out and after the startup sequence is complete (one
minute or less), the DRIVE READY indicator will light. The
DRIVE FAULT indicator will only light if a malfunction
occurs.
5-11