HP 250 - Loader Errors; Configuration Messages; Remote Workstation Failure

In Case of Difficulty
Loader Errors
If you encounter a loader error, consult the proper section in
the Appendix with error messages.
For example, if the following message:
LOADER ERI~CH( H
appears on the principal worksation, you will find that this
resulted from a disc read error (by looking in the appendix with
error messages). Loader errors A through C may indicate that the
medium holding the Operating System is worn or damaged. Try
loading the system with the backup copy of the Operating System
disc. If any loader error persists after repeated tries, record
the error message and call HP for service.
Configuration Messages
Configuration messages indicate an inconsistency in
hardware/operating system configuration. Although your HP 250
system can operate with these inconsistencies, they should be
corrected as soon as possible.
For example, if the message:
MEMOf~ Y FA:r LUt~ E oM. HL.OCf( 1 ()
appears, either the Operating System was told (via the CONFIG
Utility Program) to expect more memory than available or a memory
block has failed. Consult your principal operator to remedy this
problem. Other configuration messages are described in Appendix
E.
Remote Workstation Failure
In the event that your remote workstation is unoperable (either
the cursor does not appear or there is no response to the
keyboard), you should take appropriate action to pinpoint the
problem. By checking the workstation yourself, you may be able
to avoid calling for service.
10-3
In Case of Difficulty
Loader Errors
If you encounter a loader error, consult the proper section in
the Appendix with error messages.
For example, if the following message:
LOADER ERI~CH( H
appears on the principal worksation, you will find that this
resulted from a disc read error (by looking in the appendix with
error messages). Loader errors A through C may indicate that the
medium holding the Operating System is worn or damaged. Try
loading the system with the backup copy of the Operating System
disc. If any loader error persists after repeated tries, record
the error message and call HP for service.
Configuration Messages
Configuration messages indicate an inconsistency in
hardware/operating system configuration. Although your HP 250
system can operate with these inconsistencies, they should be
corrected as soon as possible.
For example, if the message:
MEMOf~ Y FA:r LUt~ E oM. HL.OCf( 1 ()
appears, either the Operating System was told (via the CONFIG
Utility Program) to expect more memory than available or a memory
block has failed. Consult your principal operator to remedy this
problem. Other configuration messages are described in Appendix
E.
Remote Workstation Failure
In the event that your remote workstation is unoperable (either
the cursor does not appear or there is no response to the
keyboard), you should take appropriate action to pinpoint the
problem. By checking the workstation yourself, you may be able
to avoid calling for service.
10-3