HP 250 - Page 167

Error Messages
62. File is protected, or wrong protect code specified:
Attempting to modify or purge a protected file with the
wrong protect code, or attempting to PROTECT a file that is
already protected.
63. Number of records, bytes/record, or physical sectors too
large: Cannot exceed 65534.
64. Medium overflow: There is not enough contiguous space on
the medium to store desired information.
65. Incorrect data type: Attempting to read a string value
into a numeric or vice versa.
66. Unused
67.
Parameter is <=0
ASSIGN statement,
(when rounded):
for example, is
The parameter
less than 1.
is an
68. Invalid line number encountered in mass storage operation:
The program line access by MERGE, GET, or LINK exceeds 9999
after executing any renumbering parameter.
69 - 76
Unused
77.
Specified label not found:
label not found.
Medium having the specified
78. Possible volume-label conflict: Operation performed,
however, the drive door was opened between when volume
label was identified with drive, and this operation.
79. LOAD SUB error: A requested subprogram segment is not
present or binaries are present in the program file.
80. Mass storage device door open or medium has been removed:
Data transfer cannot occur if medium is not inserted
correctly with door closed.
81. Mass storage device failure
82. Mass storage device not present: The device address has
been specified for a storage medium that is not hooked up
to the system or not present at all.
83. Mass storage device is write-protected: Attempting to
store data on a device from which data can only be
retrieved.
E-6
Error Messages
62. File is protected, or wrong protect code specified:
Attempting to modify or purge a protected file with the
wrong protect code, or attempting to PROTECT a file that is
already protected.
63. Number of records, bytes/record, or physical sectors too
large: Cannot exceed 65534.
64. Medium overflow: There is not enough contiguous space on
the medium to store desired information.
65. Incorrect data type: Attempting to read a string value
into a numeric or vice versa.
66. Unused
67.
Parameter is <=0
ASSIGN statement,
(when rounded):
for example, is
The parameter
less than 1.
is an
68. Invalid line number encountered in mass storage operation:
The program line access by MERGE, GET, or LINK exceeds 9999
after executing any renumbering parameter.
69 - 76
Unused
77.
Specified label not found:
label not found.
Medium having the specified
78. Possible volume-label conflict: Operation performed,
however, the drive door was opened between when volume
label was identified with drive, and this operation.
79. LOAD SUB error: A requested subprogram segment is not
present or binaries are present in the program file.
80. Mass storage device door open or medium has been removed:
Data transfer cannot occur if medium is not inserted
correctly with door closed.
81. Mass storage device failure
82. Mass storage device not present: The device address has
been specified for a storage medium that is not hooked up
to the system or not present at all.
83. Mass storage device is write-protected: Attempting to
store data on a device from which data can only be
retrieved.
E-6