HP 250 - Page 37

HP 250/35 Integral Workstation
Typewriter Block
Several special control keys are located on the left and right
sides of the keyboard block.
The SHIFT key enters upper case characters.
The CAPS-LOCK key locks only alphabetic keys to upper
case characters. In order to access the shifted key
characters on non-alphabetic keys, you must press the
SHIFT key. For example, if you want to enter the $ si.gn
while the CAPS-LOCK key is depressed, you must press ~,CD4:.
-I, _
The BACKSPACE key is used to move the display cursor
toward the left margin.
The CARRIAGE ~ETURN key moves the cursor to the beginning
of the next line. When SHIFT E3 is pressed, the cursor
is moved to the beginning of the present line of input.
The SET TAB key allows you to set tabs and also clear
them. You move the cursor to the desired position on the
line and then press this key to set the tab. In order to
delete any tab that you have set, move the cursor to the
tab position, and press SHIFT .
dJ
m
The ENTER key enters data into memory.
the current command.
It also executes
3-18
The TAB key moves the cursor to the first character
position of the next in~ut field or tabbed position. If
you press SHIFT0 ' the cursor will. be moved to the
first character 6f the previous input field or to the
previous tabbed position.
The CONTROL key is used to access special characters and
commands as shown throughout this chapter.
When pressed simultaneously with another key, the REPEAT
key causes that key to be repeated.
HP 250/35 Integral Workstation
Typewriter Block
Several special control keys are located on the left and right
sides of the keyboard block.
The SHIFT key enters upper case characters.
The CAPS-LOCK key locks only alphabetic keys to upper
case characters. In order to access the shifted key
characters on non-alphabetic keys, you must press the
SHIFT key. For example, if you want to enter the $ si.gn
while the CAPS-LOCK key is depressed, you must press ~,CD4:.
-I, _
The BACKSPACE key is used to move the display cursor
toward the left margin.
The CARRIAGE ~ETURN key moves the cursor to the beginning
of the next line. When SHIFT E3 is pressed, the cursor
is moved to the beginning of the present line of input.
The SET TAB key allows you to set tabs and also clear
them. You move the cursor to the desired position on the
line and then press this key to set the tab. In order to
delete any tab that you have set, move the cursor to the
tab position, and press SHIFT .
dJ
m
The ENTER key enters data into memory.
the current command.
It also executes
3-18
The TAB key moves the cursor to the first character
position of the next in~ut field or tabbed position. If
you press SHIFT0 ' the cursor will. be moved to the
first character 6f the previous input field or to the
previous tabbed position.
The CONTROL key is used to access special characters and
commands as shown throughout this chapter.
When pressed simultaneously with another key, the REPEAT
key causes that key to be repeated.