HP 250 - Page 71

Storage Devices and Media
NOTE
Do not use excessive force on
the tape eject lever. It will
not operate when power is off
or when the BUSY light is lit.
If a tape is removed from a drive under abnormal circumstances,
such as the HP 250 experiencing a tamporary power failure, you
will get an error if you insert any tape other than the one you
removed. You must re-insert the correct tape and complete the
standard unloading process described earlier. If you cannot loc-
ate the correct tape cartridge, you must run a special utility
program, which is described in the System Utilities Manual.
WARNING
The disc drive does not contain operator-
serviceable parts. To prevent electrical
shock, refer all installation and mainten-
ance activities to service-trained
personnel.
5-6
Storage Devices and Media
NOTE
Do not use excessive force on
the tape eject lever. It will
not operate when power is off
or when the BUSY light is lit.
If a tape is removed from a drive under abnormal circumstances,
such as the HP 250 experiencing a tamporary power failure, you
will get an error if you insert any tape other than the one you
removed. You must re-insert the correct tape and complete the
standard unloading process described earlier. If you cannot loc-
ate the correct tape cartridge, you must run a special utility
program, which is described in the System Utilities Manual.
WARNING
The disc drive does not contain operator-
serviceable parts. To prevent electrical
shock, refer all installation and mainten-
ance activities to service-trained
personnel.
5-6