HP 2530 SERIES User Manual

2-18
Installing the Switch
Installation Procedures
Figure 2-9. Connecting a console cable
2. Turn on the terminal or PC’s power and, if using a PC, start the PC terminal
program.
3. Press
[Enter] two or three times and you will see the copyright page and
the message “Press any key to continue”. Press a key, and you will then
see the switch console command (CLI) prompt, for example:
HP-2530-24G-PoEP#
If you want to continue with console management of the switch at this time,
see chapter 3, “Getting Started With Switch Configuration” for some basic
configuration steps. For more detailed information, refer to the Management
and Configuration Guide, which is on the HP Web site at
www.hp.com/networking/support.
Optional USB
Console cable
(not supplied)
Connect to a PC
running a terminal
emulator program, or
a VT-100 terminal
RJ-45 to DB9
Console cable
supplied with
the switch
Console port

HP 2530 SERIES Specifications

General

Model	HP 2530 Series
Category	Network Switch
Ports	8, 24, or 48 ports
Routing Protocol	Static routes
Management	Web interface, CLI, SNMP
Power Supply	Internal
PoE	Available on some models
Jumbo Frame Support	Yes
VLAN Support	Yes
Security Features	Port security, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C