Configuration procedures—VMware environments86
• Configure the VMware ESX 3.0.X Server:
1. Open the Virtual Infrastructure client and select the Configuration tab. Then select
Advanced Settings....
2. In the left-hand pane of the Advanced Settings window, select Disk. In the right-hand
pane, scroll down to Disk.MaxLUN.
3. Verify that the value is large enough to support your configuration. If the value is less
than the number of LUNs you have presented, you will not see all of your LUNs. The
maximum value for this field is 256.
• Install and configure the guest OS:
• For installation and configuration instructions, see the Guest Operating System Installation
Guide on the VMware website: http://www.vmware.com/pdf/
.
• Installing a guest OS in a virtual machine is essentially the same as installing it on a
physical computer. You can install from a CD-ROM, floppy disk, LinuxCOE, or ISO
image. If you use an ISO image file, you can store the ISO file on the host machine or on
a network drive accessible from the host machine. Use the VMware configuration tool to
connect the virtual machine’s CD drive to the ISO image file, and then power on the
virtual machine.
To Next Page
Loading...
Need help?
General
