1:2:3 OK      HP-F           8.5             No        No      Yes    Yes
1:2:4 OK      HP-F           8.5             No        No      Yes    Yes
3. Replace the SFP. See “Replacing an SFP” (page 17).
4. Issue the following commands:
• showport to verify that the ports are in good condition and the State is listed as ready:
cli%showport
N:S:P  Mode     State Node_WWN         Port_WWN/HW_Addr Type Protocol Label 
Partner FailoverState
0:0:1 initiator ready 50002ACFF70185A6 50002AC0010185A6 disk  SAS      -    
 -      -
0:0:2 initiator ready 50002ACFF70185A6 50002AC0020185A6 disk  SAS      -    
 -      -
0:1:1 target    ready 2FF70002AC0185A6 20110002AC0185A6 host  FC       -    
 -      -
0:1:2 target    ready 2FF70002AC0185A6 20120002AC0185A6 host  FC       -    
 -      -
0:2:1 target    loss_sync    -            2C27D75301F6        iscsi iSCSI   
 -     -      -
0:2:2 target    loss_sync    -            2C27D75301F2        iscsi iSCSI   
 -     -      -
0:3:1 peer      offline      -            0002AC8004DB        rcip  IP      
RCIP0  -      -
1:0:1 initiator ready 50002ACFF70185A6 50002AC1010185A6 disk  SAS      -    
 -      -
1:0:2 initiator ready 50002ACFF70185A6 50002AC1020185A6 disk  SAS      -    
 -      -
1:1:1 target    ready 2FF70002AC0185A6 21110002AC0185A6 host  FC       -    
 -      -
1:1:2 target    ready 2FF70002AC0185A6 21120002AC0185A6 host  FC       -    
 -      -
1:2:1 initiator loss_sync 2FF70002AC0185A6 21210002AC0185A6  free  FC  -    
 -      -
1:2:2 initiator loss_sync 2FF70002AC0185A6 21220002AC0185A6  free  FC  -    
 -      -
1:2:3 initiator loss_sync 2FF70002AC0185A6 21230002AC0185A6  free  FC  -    
 -      -
1:2:4 initiator loss_sync 2FF70002AC0185A6 21240002AC0185A6  free  FC  -    
 -      -
1:3:1 peer      offline       -            0002AC8004BD      rcip  IP       
RCIP1 -      -
• showport -sfp to verify that the replaced SFP is connected and the State is listed as
OK:
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK      HP-F           8.5             No        No      No     Yes
0:1:2 OK      HP-F           8.5             No        No      No     Yes
0:2:1 OK      AVAGO          10.3            No        No      Yes    Yes
0:2:2 OK      AVAGO          10.3            No        No      Yes    Yes
1:1:1 OK      HP-F           8.5             No        No      No     Yes
1:1:2 OK      HP-F           8.5             No        No      No     Yes 
1:2:1 OK      HP-F           8.5             No        No      Yes    Yes
1:2:2 OK      HP-F           8.5             No        No      Yes    Yes
1:2:3 OK      HP-F           8.5             No        No      Yes    Yes
1:2:4 OK      HP-F           8.5             No        No      Yes    Yes
16 Servicing the Storage System