Does the connection to the CP require proxy services? (yes or no) [no]
no
17. Type the IP address for the connection system and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for <system_name>:
<system.IP.address>
18. Press ENTER to accept the default router address, or type an alternate router address and press
ENTER.
Please enter the IP address of the router to reach
stdev.3pardata.com, or NONE: [<default.router.address>]
[enter]
19. Type the external NTP system address (if applicable) or none and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Enter the IP address of an external NTP system
<NTP.system.address>
20. Press ENTER or type yes to configure the SP firewall in permissive mode.
SP Network Parameters
Enter Control-C at any time to abort this process
The SP firewall protects the SP and the customer network from unauthorized use.
It can be configured in permissive mode to allow any host to connect to the SP
via SSH and HTTP.
Do you wish to configure the SP firewall in permissive mode? [yes/no][yes]
yes
21. Press ENTER or type yes and press ENTER to verify the network information you have supplied.
Some items appear only when applicable so the screen content can differ according to the
setup options you have chosen.
SP Network Parameters - Confirmation
Enter Control-C at any time to abort this process
The Host Name is: SPXXXXX
- Public IP address: <static.IP.address>
- Netmask: <subnet.mask.address>
- Gateway: <default.gateway.address>
- Network Speed: AUTO
PERMISSIVE FIREWALL MODE SELECTED
Manually Setting up the Service Processor 39
To Next Page
Loading...
