HP 40gs - Stat-Two Commands

21-30 Programming
Stat-One commands
DO1VSTATS Calculates STATS using datasetname and stores the
results in the corresponding variables: NΣ, TotΣ, MeanΣ,
PVarΣ, SVarΣ, PSDev, SSDev, MinΣ, Q1, Median, Q3,
and MaxΣ. Datasetname can be H1, H2, ..., or H5.
Datasetname must include at least two data points.
DO1VSTATS datasetname:
SETFREQ Sets datasetname frequency according to column or
value. Datasetname can be H1, H2,..., or H5, column
can be C0–C9 and value can be any positive integer.
SETFREQ datasetname;column:
or
SETFREQ definition;value:
SETSAMPLE Sets datasetname sample according to column.
Datasetname can be H1–H5, and column can be
CO–C9.
SETSAMPLE datasetname;column:
Stat-Two commands
DO2VSTATS Calculates STATS using datasetname and stores the
results in corresponding variables: MeanX, ΣX, ΣX2,
MeanY, ΣY, ΣY2, ΣXY, Corr, PCov, SCov, and RELERR.
Datasetname can be SI, S2,..., or S5. Datasetname must
include at least two pairs of data points.
DO2VSTATS datasetname:
SETDEPEND Sets datasetname dependent column. Datasetname can
be S1, S2, …, or S5 and column can be C0–C9.
SETDEPEND datasetname;column:
SETINDEP Sets datasetname independent column. Datasetname can
be S1, S2,…, or S5 and column can be C0–C9.
SETINDEP datasetname;column:
hp40g+.book Page 30 Friday, December 9, 2005 12:27 AM