Install Upgrade Page
Message Explanation / Remedy
Please enter a valid path to the upgrade file, or click
Browse to find the saved upgrade file.
When attempting to upgrade, no upgrade file was
specified. Type the complete path to the firmware
image (for example, "C:\TEMP\UPGRADE.HP") or
click Browse to find the saved firmware image.
No file was provided with the upgrade request. No upgrade file was transferred to the appliance.
Retype the complete path to the firmware image (for
example, "C:\TEMP\UPGRADE.HP") or click
Browse to find the saved firmware image. If the
filename is unknown, access HP's website and
download the upgrade image
(http://www.hp.com/cposupport).
The specified file is not a valid print server appliance
upgrade file.
Retype the complete path to the firmware image (for
example, "C:\TEMP\UPGRADE.HP") or click
Browse to find the saved firmware image.
An I/O Error occurred while transferring the file. The specified filename is not a valid upgrade file.
Retype the filename and try again.
The upgrade file has been transferred successfully.
You will need to restart your print server appliance for
the upgrade to take effect.
Confirmation message.
Restart Appliance Page
Message Explanation / Remedy
The restart of the print server appliance has begun.
This system restart will take approximately 5-10
minutes. There will not be any web notification that
the system has been restarted.
Confirmation message.
TCP/IP Page
Message Explanation / Remedy
Invalid IP Address
The IP address must be in the format xxx.xxx.xxx.xxx.
IP addresses are written as four numbers separated
by periods, where the first number is between 1 and
255 and the other three numbers are between 0 and
255. Retype the IP address in the format
xxx.xxx.xxx.xxx.
To Next Page
Loading...
